"eBike" cables (Julet / Okfeet / Baming / Hugo) 20/40/80cm

• Julet / Okfeet / Baming / Hugo / M8 cables are a common interconnect for eScooter and eBike handlebar connections and a great way to connect accessories or tap into existing handlebar wiring circuits.
• These cables are a common interconnect for eScooter and eBike handlebar connections. Range includes prepared leads in 20mm (shorties), and 80cm, or single connector at one end only with flyleads at the other.

• Durable, waterproof design.
• Many of these are custom order fabricated for production specifically for eScootNow (Nami Harness manufacturer Baming).
• The fully prepared leads have a choice of three connector polarities (M-F, M-M, M-F) or as a half prepared lead with a specific polarity connector with flylead on other end. Gender is based on conductive pins, not housing.
• Pins and colours

Red = 2-Pin
Yellow = 3-Pin
Blue = 4-Pin
Green = 5-Pin
Black = 6-Pin (product image not shown)
Black = 7-Pin* (Nami style)

* = The 7-Pin configuration is one whereby one pin resides in centre as used on stem and deck main lines on Nami Burn-E ("Viper") eScooter.

Outer multipcore wire diameter: 3.7mm (5.5mm for 7 and 10-pin).
Cable length (including connectors): 10cm, 40cm or 80cm on flyleads (semi-prepared leads with flylead one end, moulded connector fitted other end) and 10cm, 20cm or 80cm on fully prepared leads (moulded connectors are fitted on both ends).
Plug diameter: 9mm (Commonly known as M8, rather than the smaller M6).
Plug length: 35mm.